Bear Royale RTH 27″ Compound Bow Review

Performance

With a stated 290 fps IBO speed and a 75% let-off, the Bear Royale RTH 27 aims for easy holding and repeatable shots rather than maximum punch. The short 27 in axle-to-axle length also helps new shooters keep the bow steady through the shot. That length matters because beginners often steer the bow during release, and a shorter platform tends to feel more manageable.

On the draw side, the adjustable 5-50 lb draw weight and 12-27 in draw length give you room to dial in proper form. When the bow is set to your real draw length, your anchor and release timing become more consistent. That consistency often shows up faster on paper targets than “peak speed” ever does.

Still, the trade-off is real. The “Lower arrow speed” note aligns with the 290 fps IBO figure. If you are used to faster hunting compounds, this bow can feel less urgent on impact. For many beginners, that is fine. For anyone chasing flatter trajectories at longer range, you will notice the gap in performance.

Build Quality

Build quality is solid enough for beginner use, which matches the pillar score of 7.7 and the “great” descriptor: rugged limbs and hardware. The bow uses a compact 27 in axle-to-axle format with a 6 in brace height. Those two numbers matter because they influence system balance and the leverage your arms see during long sessions. A short axle-to-axle bow is often easier to handle during routine maintenance and transport, and that can indirectly support long-term durability.

There is also enough adjustment range to avoid forcing the bow into a setup that feels “almost right.” You can tune within a 5-50 lb draw weight window and a 12-27 in draw length window. When a bow can match your needs, you tend to shoot in better form, and that reduces the wear patterns that come from poor alignment and repeated bad releases.

One caution shows up in the cons: “Likely poor fit” and “Too long and bulky.” Those are fit complaints, not direct parts failures. But they still affect how the bow gets carried, mounted, and stored. If your body position does not match the bow’s form factor, you can end up stressing adjustments more often. That is where build quality can feel less “rugged” in real life.

Ergonomics

Ergonomics land at 7.9, which puts it in the “great” zone: comfortable grip, balanced feel. The key numbers support that. The 27 in axle-to-axle length helps with bow control during aiming. The 6 in brace height also plays into how the bow feels at full draw, since it affects the timing of when your body takes over and your release cycle settles.

The 75% let-off is the ergonomic story that beginners feel right away. With 75% let-off, you hold at reduced holding weight while staying at full draw. Combined with the 12-27 in draw length adjustment and the 5-50 lb draw weight range, you can set the bow so your anchor point becomes repeatable. Repeatability reduces fatigue, which is the real enemy of good form.

Bear Royale RTH 27 gets described as “Stable starter handling,” and that aligns with the way these ergonomics numbers tend to work together. The main ergonomic downside is not harshness from vibration, at least based on the scoring and the target beginner role. The bigger issue is that the bow can feel like “Too long and bulky” if your build or shooting lane setup does not match a 27 in axle-to-axle platform.

Versatility

Versatility scores 7.8, landing in the “easy setup across draw lengths” bucket. The adjustment range is wide in a way that matters for beginners: 12-27 in draw length and 5-50 lb draw weight. Most first-time archers get one of those wrong when buying sighted equipment. This bow gives you room to correct that mistake without changing platforms.

The let-off level also supports usability across different strength levels. At 75% let-off, the bow can feel manageable as you approach your intended full-draw position. That matters because the 5-50 lb draw weight window spans big gaps in grip and back tension needs. A beginner who starts at a lower draw weight can still hold at full draw without fighting the pull every time.

The limitation is not the adjustment range. It is the bow’s overall feel. “Likely poor fit” and “Too long and bulky” point to real-world constraints. The 27 in axle-to-axle length can work well for many shooters, but it can also crowd your stance if you prefer a more compact feel. Versatility still exists on paper, but comfort and form may decide whether you truly stick with it.

Value

Value scores 7.9, which maps to “Strong performance for price” in the descriptor system. This bow targets beginner learning, and the specs back that learning curve. You get a 290 fps IBO speed to start, but you also get a workable 27 in axle-to-axle size and a 6 in brace height that support stable handling. That combination tends to reduce the frustration loop that happens when a bow feels hard to keep on target.

From a form standpoint, the 5-50 lb draw weight range and 12-27 in draw length range are the practical value drivers. They let the bow fit a wider group of users while they develop anchor consistency and release timing. The 75% let-off then makes the practice reps less punishing because you spend more time shooting than recovering.

The value trade-off is the one the cons admit: “Lower arrow speed.” The 290 fps IBO figure sets expectations. If you measure value only by speed, you will feel held back. If you measure value by how easily the bow turns into consistent shots, the 75% let-off and the adjustment windows do enough work to justify the asking role in a starter kit.